2024 Ford Explorer

The center display went blank and a/c controls under it would not work. Stopped vehicle and pushed ignition button to off and waited 1 minute and pushed ignition back to on on and display was still blank. Got to destination and pushed ignition to off. The next day when I got into vehicle and pushed ignition button to on the display worked.

have been getting a warning coming up saying pre-collision sensor not available sensor blocked over 100 times brought it to the dealership and they said that the bracket for the sensor is broken due to road debris, impact or snow and ice buildup with no evidence of any damage

During a severe, multi-lane impact crash, the second-row outer seatbelts completely failed to maintain restraint and failed to retract. Both occupants in the second-row outer seating positions (ages 5 and 7) sustained visible seatbelt friction burns on their arms from the initial impact, but immediately following the crash, both seatbelts were found completely broken, with all slack pulled completely out and zero mechanical retraction. Both children were found entirely unbuckled and unrestrained immediately following the impact. This vehicle is a Ford Explorer, and this failure matches the exact criteria of an active manufacturer safety recall noted on my insurance documentation (NHTSA Campaign ID: 26V159000 / Ford Recall No: 26C18) regarding second-row outer seatbelt anchor bolts being improperly secured. The vehicle has been declared a total loss, but the components are preserved and currently available for inspection upon request under a temporary insurance evidence hold. How safety was put at risk: The safety of two young children was severely compromised. Because the second-row seatbelt mechanisms or anchor bolts failed mid-crash, the children were left entirely unrestrained and unbuckled inside a moving, colliding vehicle after the initial impact, vastly increasing their risk of severe secondary impact injuries. Has the problem been confirmed by a dealer/independent center? UNKNOWN. The failure occurred during the crash, and the vehicle was towed directly to a holding lot. Has it been inspected by others? The vehicle has been documented by insurance representatives for valuation purposes, but a dedicated mechanical inspection of the failed seatbelt components has not yet been performed. Were there warning lamps or prior symptoms? NO. There were absolutely no warning lights, messages, loose seatbelt components, or mechanical symptoms prior to the crash. The system appeared to be functioning normally until it failed under the stress of the impact.

pre-collision warning light comes up, saying sensor blocked and sensor is not blocked. Brought it to the local dealership found that the cruise control module bracket is damaged no visible damage or strikes to the bumper dealership says not under warranty, and Ford is aware of a widespread issue with the bracket snapping on the sensor behind the front bumper

Rear windshield wiper doesn't work. Earlier model years have been recalled for wiper motor issues.

• Driver seat not setting its memory for the driver , and will move on its own and go all the way to dash while setting in it or all the way back . Has happened multiple times and also twice while driving. • Safety at risk could have made me wreck my vehicle if I hadn’t pulled over and the seat stopped what it was doing front and back. • yes , been checked by dealership (4) times in service department. •yes, every code on the dash has appeared and lasted a total 20 minutes and car went into limp mode. Couldn’t turn car on or off. First happen in Dec 2025. There has been multiple issues with this vehicle since I bought it from the first month.

The headrest on the third row is locked in the upright position and won't fold down. I've looked online and it seems to happen in every ford explorer in the current generation, 2020+. I see hundreds of complaints online. Across the forums and reddit.

Visual blurry defect in windshield glass in driver side