2019 Mazda Mazda3

The driver-side sun visor has suffered an internal mechanical failure where the internal plastic tension components have cracked under normal use. As a direct result, the sun visor will not stay up and randomly drops down completely unprompted while the vehicle is in motion. This creates an immediate, sudden, and dangerous visibility hazard by blocking my forward view of the road while driving.Mazda has formally recognized this specific engineering defect across 2019–2025 Mazda 3 vehicles in Technical Service Bulletin (TSB) MC-11016209-0001, explicitly stating that the internal stay components crack. However, because Mazda has only issued a TSB and not a safety recall, out-of-warranty owners are forced to pay out-of-pocket to repair a component critical to safe driving visibility. This issue needs to be escalated to a formal safety recall before it causes an accident due to forward view obstruction.

1. What component or system failed or malfunctioned, and is it available for inspection upon request? The airbag system, specifically the curtain airbags and related airbag control components, malfunctioned by deploying spontaneously without any collision or impact. The vehicle and deployed airbags are still available and can be inspected upon request. 2. How was your safety or the safety of others put at risk? The spontaneous deployment of all four curtain airbags created an immediate safety hazard. Airbag deployment can cause injury, disorientation, or loss of control, especially if it occurs unexpectedly. Although the vehicle was stationary at the time, deployment without warning posed a serious risk of injury to occupants and could have resulted in a crash if it had occurred while driving. 3. Has the problem been reproduced or confirmed by a dealer or independent service center? The problem has not been reproduced, as the airbags have already deployed. However, the spontaneous deployment itself is clear evidence of a malfunction. The issue has not been resolved or repaired, and responsibility for repair has not been accepted. 4. Has the vehicle or component been inspected by the manufacturer, police, insurance representatives, or others? The incident was reported to Progressive Insurance, which denied coverage because there was no accident or collision. The vehicle has not yet been inspected by the manufacturer for defect analysis. No police inspection occurred because there was no crash or injury. 5. Were there any warning lamps, messages, or other symptoms of the problem prior to the failure, and when did they first appear? Yes. The airbag warning light was illuminated prior to the incident, indicating a potential system fault. Additionally, a strong chemical odor was noticed inside the vehicle immediately before deployment, originating from the front passenger side, moments before all four curtain airbags deployed.

Driver side door handle failed. Cannot enter or exit through driver side door. If something were to happen that we need to get out in an emergency situation we cannot exit through the driver side door. No damage occurred. Just stopped working

To whom it may concern, I was on a back road late in the evening not far from home [XXX] and a small deer ran into the road. I needed to brake to avoid hitting the deer. After breaking, a Brake System Malfunction warning message and i-ACTIVESENSE System Malfunction warning illuminated on my dashboard. I brought the car to a Mazda dealership the next morning. The technician determined that the brake fluid level sensor became stuck, requiring replacement of the brake fluid reservoir and the brake fluid level sensor. What failed: The repairs include replacement of the Brake Fluid Reservoir and the Brake Fluid Level Sensor. This is the link to the dealer report [XXX] . No one other than the dealer has inspected these parts to my knowledge. There was no accident of any kind. I personally felt unsafe after these parts failing and reached out to Mazda Customer Care to request investigation of the issue. The case manager just called me back today to say they could not help me. Mazda has denied warranty coverage, claiming the parts are not covered. However, I really do feel this is a critical safety system component that failed after normal emergency use with no collision or impact. Why I feel this is a safety concern: - The brake warning system became unreliable after a single emergency stop. - My car only has 42k miles and is in excellent condition and is fully dealer serviced. - A driver could lose the ability to receive proper brake system warnings if this failure occurs again. - A critical brake sensor should not fail under normal driving conditions, and its failure could lead to delayed driver response in an actual brake fluid loss scenario. It makes me worry for the future. For your consideration: I believe this represents a safety-related defect that should be investigated, as it affects the reliability of the brake system warning indicators in the 2019 Mazda 3. I appreciate your time and consideration. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The seat belt stopped retracting and no longer works, it was reported directly to the Mazda agency, but the warranty was not valid. The dealer said that the tensioners no longer work and the seat belt needs to be replaced.

For the seat belt it does not retract back and there was no issue before. It suddenly stopped working and all of the seatbelt is out. This is a safety issue for anyone sitting in the front passenger seat. For the unknown part the button in the trunk to pull the back passenger seats down suddenly stopped working and no issues before then. I’m more concerned with the seat belt because this is a huge safety concern and issue. The seatbelt does not retract at all, leaving it completely extended and unusable. This issue occurred without any prior incident, accident, or external damage—it simply stopped working. This failure poses a serious safety risk, as the seatbelt cannot properly restrain a passenger in case of a sudden stop or crash. I have checked for recalls on my vehicle but found none related to this issue. I request that NHTSA investigate this issue, as it may indicate a manufacturing defect. If necessary, I would also like to request a recall or manufacturer repair program to address this safety concern.

A few weeks ago the following error message popped up on my dashboard: “Airbag Malfunction. Have vehicle inspected”. This message came and went intermittently whenever I had a passenger in the vehicle. I scheduled and appointment at my local Mazda dealership service center and in the meantime looked up the issue and found that it was extremely common and caused by a design flaw where the wire harness to the seat airbags was too short causing eventual failure. The issue was so prominent that Mazda even issued a service bulletin on how to fix it which included replacing the wire harness and adding extra security clips to help prevent future failure. So I get my car to the service center and after looking at it they confirm this exact issue, say it is not covered under any extended warranty and tell me that it will cost approximately $1,000 to fix (diagnostic, parts plus labor). I asked how a safey issue such as an airbag not deploying isn’t covered and they reaffirm that it is NOT a safety issue and that there is no recall for it nor would it fail inspection with that error message. They also did confirm that in the event of an accident that airbag would not deploy while that error message was showing. I am at a loss right now and am not sure what to do as I cannot afford a $1,000 fix and am very confused as to how this design flaw for what I believe to be a safety issue is not covered under a recall.

This began on 10.19.24 and as of 11.03.24 is ongoing and not repaired. On 10/19/24, while I was at a red light, the RPMs on my vehicle went up and down repeatedly. After I arrived at my destination, which was about a half mile away, and put the car in park, the RPMs repeatedly went up and down between 1,000 and 2,000 RPMs and the check engine light came on, and a message displayed saying malfunction - have the vehicle inspected. I spent $100 at my mechanic who could not pinpoint the issue. After I picked up the car, I stopped to get gas and then my battery died. I then decided to take my car to the dealer where I purchased it, Mazda of Roswell. After I put the car in park at the Mazda of Roswell service department, the RPMs started going back and forth between 1,000 and 2,500 RPMs. My car spent 6 days at Mazda of Roswell, where the service dept was unresponsive and my car was never inspected. I then spent $1600 at North Roswell Automotive, only to have the issue appear again after driving less than two miles. I am not sure it is safe to drive a vehicle in which the RPMs are unstable. So far this has only happened when the car is idling or in park. If it happens when the car is in motion I hope I am able to control the vehicle. My car needs service at a Mazda dealer but I need the dealer to be honest with me about what to expect in terms of how long it will take to address the issue. Since this is an engine issue, this issue could be something that causes the car to stall or fail at any time, including while I am in traffic; it could also be electrical, since the battery suddenly died without warning. This would place myself and others on the road in danger. I purchased the battery just over one year ago, so I do not know if there is an issue there.